Filter
Top Products
Rack Airflow Requirements
Rack Airflow RequirementsRack Airflow Requirements
Rack Airflow Requirements
Rack 9000 and 10000 series Cabinets
The increasing power of new high-performance processor technology requires increased cooling efficiency for rack-
mounted servers. The Compaq 9000 Series Rack and the new 10000 Series Racks provides enhanced airflow for
maximum cooling, allowing these racks to be fully loaded with servers using the latest processors.
Rack 7000 series Cabinets
When installing a server with processors running at speeds of 550 MHz or greater in Compaq Rack 7000 series racks
with glass doors (165753-001 (42U), and 163747-001 (22U)), the new processor technology requires the
installation of Compaq’s new High Airflow Rack Door Inserts (327281-B21 (42U), 327281-B22 (42U 6 pack), or
157847-B21 (22U)) to promote enhanced airflow for maximum cooling.
CAUTION:
CAUTION: CAUTION:
CAUTION:
If a third-party rack is used, observe the following additional requirements to ensure adequate airflow and to
prevent damage to the equipment:
Front and rear doors:
If your 42U server rack includes closing front and rear doors, you must allow 830
square inches (5,350 sq cm) of hole evenly distributed from top to bottom to permit adequate airflow
(equivalent to the required 64 percent open area for ventilation).
Side:
The clearance between the installed rack component and the side panels of the rack must be a
minimum of 2.75 inches (7 cm).
CAUTION:
CAUTION: CAUTION:
CAUTION:
Always use blanking panels to fill all remaining empty front panel U-spaces in the rack. This arrangement
ensures proper airflow. Using a rack without blanking panels results in improper cooling that can lead to thermal damage.
NOTE:
NOTE: NOTE:
NOTE:
For additional information, refer to the Setup and Installation Guide or the Documentation CD provided with the
server, or to the server documentation located in the Support section at the following URL:
http://h18000.www1.hp.com/products/servers/ProLiantdl760/index.html
.
Service and Support
Service and SupportService and Support
Service and Support
HP Services provides a three-year, limited warranty, including Pre-Failure Warranty (coverage of hard drives, memory and
processors) fully supported by a worldwide network of resellers and service providers. HP technical assistance is available
7x24, toll free in the United States and Canada. Telephone support services may be covered under warranty or available for
an additional fee.
NOTE:
NOTE: NOTE:
NOTE:
Limited Warranty includes 3 year Parts, 3 year Labor, 3-year on-site support.
A full range of HP Care Pack packaged hardware and software services:
Installation and start up
Extended coverage hours and enhanced response times
System management and performance services
Availability and recovery services
NOTE:
NOTE: NOTE:
NOTE:
For more information, customer/resellers can contact
http://www.hp.com/hps/
.
Please see the following URL regarding Warranty Information For Your HP Products:
http://h18004.www1.hp.com/products/servers/platforms/warranty/index.html
.
For additional information regarding Worldwide Limited Warranty and Technical Support, please see the following URL:
ftp://ftp.compaq.com/pub/supportinformation/ejourney/176738.pdf
.
NOTE:
NOTE: NOTE:
NOTE:
Certain restrictions and exclusions apply. Consult the Customer Support Center at 1-800-345-1518 for details.
QuickSpecs
Compaq ProLiant DL380 G2
Compaq ProLiant DL380 G2Compaq ProLiant DL380 G2
Compaq ProLiant DL380 G2
Standard Features
DA - 10902 Worldwide — Version 50 — September 30, 2003
Page 6