Filter
Top Products
Power connector cable
Description Spare part number
Power connector cable 454945-001
Before removing the power connector cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
Battery on page 37).
5.
Remove the following components:
a.
Hard drive (see
Hard drive on page 38)
b.
Optical drive (see
Optical drive on page 44)
c.
Keyboard (see
Keyboard on page 46)
d.
Switch cover (see
Switch cover on page 49)
e.
Display assembly (see
Display assembly on page 51)
f.
Top cover (see
Top cover on page 56)
g.
System board (see
System board on page 66)
Remove the power connector cable:
1.
Turn the system board upside down, with the external monitor connector toward you.
2. Disconnect the power connector cable (1) from the system board.
3. Remove the power connector cable (2).
Reverse this procedure to install the power connector cable.
76 Chapter 4 Removal and replacement procedures