Filter
Top Products
3. Remove the battery pack(s) (Section 5.3.3).
4. Remove the auxiliary battery (Section 5.3.4).
5. Remove the hard drive (Section 5.3.5).
6. Remove the battery or mass storage device from the MultiBay (Section
5.3.6).
7. Remove any PC cards (section 5.3.7).
NOTE: It is important that these instructions be followed when replacement
of any part requires removal of the display assembly:
Slide the display assembly back in place and replace all screws. The
screws must be fully tightened to ensure that they do not touch the
expansion base sensor located near the left hinge. Failure to properly
seat the screws may prevent the unit from booting up.
5.3.1 Undocking the Computer
If the computer is not docked in an expansion base, proceed to Section
5.3.2. If the computer is docked in an expansion base, see Figure 5-3 and
complete the following steps to undock the computer:
1. Turn off the power [1] to the expansion base.
2. Pull the docking lever forward [2] to release the computer and lift the
computer out of the expansion base.