Filter
Top Products
P
RESARIO
N
OTEBOOK
M
AINTENANCE
AND
S
ERVICE
G
UIDE
1800 S
ERIES
B
ATTERY
AND
P
OWER
M
ANAGEMENT
5
Presario 1800 Series
Models: XL180, XL181, XL182, XL183, XL185,
and XL190, XL191, XL192
Rebooting After a Lockup
To reboot the Notebook when the keyboard is frozen or the screen is locked, press and hold
down the Power
ª
button for at least four seconds; this causes a Manual Shutdown. Then,
restart the Notebook with a single press of the Power
ª
button.
If the Notebook still does not recover, press the Power
ª
button and hold for four seconds
to shut it down, and then remove the battery and unplug the AC power for at least 30
seconds. Reinsert the battery or reconnect AC power and press the Power
ª
button once
to reboot.
Recovering From a Loss of Electrical Power
Loss of electrical power causes the Notebook to turn off automatically. This may cause loss
of data because the Microsoft Windows operating system is not able to close all files and
programs properly.
Loss of power may be caused by one of the following:
• Electrical power service is interrupted.
• The power cord is accidentally disconnected.
If power surges or sags, the display and status lights may flicker, and the Notebook may
automatically restart. If an improper shutdown occurs, ScanDisk, a Microsoft Windows
utility program, runs automatically once power is restored. ScanDisk determines if the
improper shutdown caused any errors on the hard disk. These errors may occur if the
Microsoft Windows operating system is not able to close all files properly before the
shutdown. If no errors are found, the restart process continues. If ScanDisk does detect
errors, follow the instructions on the screen to continue the restart process. Work that was
not saved before the loss of power or shutdown may be lost.
If a power failure occurs, or the power cord disconnects while the Notebook is turned on,
turn it off until normal service is restored. The next time the Notebook is turned on,
ScanDisk may run to check the hard disk for errors caused by improper shutdown.