Filter
Top Products
Chapter 3 - Hardware Installation 9
Chapter 3 - Hardware Installation
RISC Router 3500R Back Panel
This section of the manual describes how to connect the RISC Router
3500R to your Ethernet network and your wide area communications
device(s). In summary, the steps for installation are:
1. Make sure the router is powered down and not connected to any
power source.
2. Connect the router to the Ethernet network.
3. Connect the router to the wide area line communications device(s).
4. Power up the line communication devices.
5. Plug in the power cable and power up the router.
Mounting the Router
The RISC Router 3500R can be mounted in a variety of different ways,
or can be left standalone on a desktop or equipment table.
v
Note: When stacking other equipment on the RISC Router 3500R, do
not exceed 25 pounds of evenly distributed weight on top of the router.
Additional weight may bend the case.
A rack/wall mounting kit is included with the router.