Crestron electronic CP-X3014WN/ Projector User Manual


 
20
3.1 Projector Web Control - Network Settings (continued)
3. Web Control
Item Description
Wireless Setup Configures the wireless LAN settings.
Mode Select “AD-HOC” or “Infrastructure”.
IP Configuration Configures network settings.
DHCP ON Enables DHCP.
DHCP OFF Disables DHCP.
IP Address Configures the IP address when DHCP is disabled.
Subnet Mask Configures the subnet mask when DHCP is disabled.
Default
Gateway
Configures the default gateway when DHCP is disabled.
DNS Server Address Configures the DNS server address.
Ch
Select from “1” to “11” a channel to use in the AD-HOC mode.
Encryption Select data encryption method.
WEP Key
Input the WEP key.
Either ASCII characters or hexadecimal numbers can be
used during WEP key input. The length of the key is defined
as follows according to the WEP and character formats.
Encryption ASCII characters HEX numbers
WEP 64bit 5 characters 10 characters
WEP 128bit 13 characters 26 characters
WPA Passphrase
Input WPA Passphrase.
Available number of input characters is 8 to 63. Only
alphabets, numbers and following symbols can be used.
!"#$%&'()*+,-./:;<=>?@ [\]^_`{|}~ and space
SSID
Select an SSID from the list.
If you require to set your unique SSID, select [Custom], then
set your own SSID following the rules below.
Maximum number of input characters is 32.
Only alphabets, numbers and following symbols can be used.
!"#$%&'()*+,-./:;<=>?@[\]^_`{|}~ and space.
(continued on next page)
• Depending on the country where you are
the channels may vary. In addition, depending on the
country or region where you are may be required to use a
wireless network card that confirm to the standards in the
respective country or region.
NOTE