Crestron electronic PW-2407RU Power Supply User Manual


  Open as PDF
of 8
 
Crestron PW-2407RU Power Pack
Setup
Complete the following steps to properly set up and connect the power
pack. Refer to the illustration that follows this procedure.
1. Attach the white striped lead to the 24 pin on the Cresnet connector
of the device to be powered.
2. Attach the lead with writing to the G pin on the Cresnet connector
of the device to be powered.
3. Attach the line cord (supplied) to the IEC connector on the power
pack.
4. Insert the power pack into an active AC receptacle.
PW-2407RU Power Pack Hookup
24 Y Z G
AC
RECEPTACLE
AC LINE CORD
PW-2407RU
POWER PACK
CRESNET
DEVICE
WHITE STRIPED LEAD
Installation Guide – DOC. 6733A Power Pack: PW-2407RU • 3
 previous next