Filter
Top Products
CY7C1380D, CY7C1382D
CY7C1380F, CY7C1382F
Document #: 38-05543 Rev. *F Page 10 of 34
Truth Table
The Truth Table for this data sheet follows.
[4, 5, 6, 7, 8]
Operation Add. Used CE
1
CE
2
CE
3
ZZ ADSP ADSC ADV WRITE OE CLK DQ
Deselect Cycle, Power Down None H X X L X L X X X L-H Tri-State
Deselect Cycle, Power Down None L L X L L X X X X L-H Tri-State
Deselect Cycle, Power Down None L X H L L X X X X L-H Tri-State
Deselect Cycle, Power Down None L L X L H L X X X L-H Tri-State
Deselect Cycle, Power Down None L X H L H L X X X L-H Tri-State
Sleep Mode, Power Down None X X X H X X X X X X Tri-State
READ Cycle, Begin Burst External L H L L L X X X L L-H Q
READ Cycle, Begin Burst External L H L L L X X X H L-H Tri-State
WRITE Cycle, Begin Burst External L H L L H L X L X L-H D
READ Cycle, Begin Burst External L H L L H L X H L L-H Q
READ Cycle, Begin Burst External L H L L H L X H H L-H Tri-State
READ Cycle, Continue Burst Next X X X L H H L H L L-H Q
READ Cycle, Continue Burst Next X X X L H H L H H L-H Tri-State
READ Cycle, Continue Burst Next H X X L X H L H L L-H Q
READ Cycle, Continue Burst Next H X X L X H L H H L-H Tri-State
WRITE Cycle, Continue Burst Next X X X L H H L L X L-H D
WRITE Cycle, Continue Burst Next H X X L X H L L X L-H D
READ Cycle, Suspend Burst Current X X X L H H H H L L-H Q
READ Cycle, Suspend Burst Current X X X L H H H H H L-H Tri-State
READ Cycle, Suspend Burst Current H X X L X H H H L L-H Q
READ Cycle, Suspend Burst Current H X X L X H H H H L-H Tri-State
WRITE Cycle, Suspend Burst Current X X X L H H H L X L-H D
WRITE Cycle, Suspend Burst Current H X X L X H H L X L-H D
Notes
4. X = Don't Care, H = Logic HIGH, L = Logic LOW.
5. WRITE
= L when any one or more byte write enable signals, and BWE = L or GW = L. WRITE = H when all byte write enable signals, BWE, GW = H.
6. The DQ pins are controlled by the current cycle and the
OE
signal.
OE
is asynchronous and is not sampled with the clock.
7. The SRAM always initiates a read cycle when ADSP
is asserted, regardless of the state of GW, BWE, or BW
X
. Writes may occur only on subsequent clocks
after the
ADSP
or with the assertion of
ADSC
. As a result,
OE
must be driven HIGH prior to the start of the write cycle to allow the outputs to tri-state.
OE
is a
don't care for the remainder of the write cycle.
8.
OE
is asynchronous and is not sampled with the clock rise. It is masked internally during write cycles. During a read cycle all data bits are tri-state when
OE
is
inactive or when the device is deselected, and all data bits behave as output when
OE
is active (LOW)
.
[+] Feedback