Filter
Top Products
Windows 95 and 98 Printer Driver Installation and Technical Reference 15
Setting 450 Printer Configuration Options
The information that follows explains how to change the 450 printer configuration to
work with the printer driver for Windows 95 or 98.
Disabling Auto Remake
1. Press the READY button. The message, “Operator Setup Press Option Key”
appears.
2. Press the OPTION button eight times. The current Auto Remake setting
appears.
3. If necessary, press the ENTER button to set Auto Remake to Off.
4. Press the READY button.
Setting Communication Parameters
1. Press the READY button. The message, “Operator Setup Press Option Key”
appears.
2. While pressing and holding the READY button, press the EXIT button two
times and the OPTION button two times, and then release the READY button.
The message Cust. Eng. Setup Press Option Key appears.
3. Press the OPTION button two times.
4. Press the ENTER button. The current Baud Rate setting appears.
5. If necessary, press the ENTER button until 9600 is displayed.
The printer scrolls through the Customer Engineer Setup options as you
press the OPTION button. To back up to an earlier option, press and hold
the READY button, and then press the OPTION button.
6. Press the OPTION button. The current Parity setting appears.
7. If necessary, press the ENTER button until None is displayed.
8. Press the OPTION button. The current Bits/Char setting appears.
9. If necessary, press the ENTER button until 8 is displayed.
10. Press the OPTION button. The current Stop Bits setting appears.
11. If necessary, press the ENTER button until 1 is displayed.
12. Press the OPTION button. The current Parity Err Actn setting appears.
13. If necessary, press the ENTER button until Halt is displayed.
14. Press the OPTION button. The current Input End of Line setting appears.