Filter
Top Products
6
9. AUX Video Input (D-Sub 9-Pin):
An additional video input terminal with RGB and Sync input interface. Connect the
Pin 7 to Ground (Short the Pin 7 & 8) to activate this interface and turn on the 12VDC
power output on Pin 1 & 6.
PIN 1: 12VDC 300mA output
PIN 2: Video “R”Input
PIN 3: Video “G”Input
PIN 4: Video “CV_Sync”Input
PIN 5: Video “B”Input
PIN 6: 12VDC 300mA output
PIN 7: SDI Switch (Connect to Ground to enable RGB Input of Pin 2-5)
PIN 8: Ground
PIN 9: Ground
10. DIP Switch setting for DV Input mode select
Please refer to the setting below for proper operation.
(See Note 1 below)
S1. PAL or NTSC (PAL-ON, NTSC-OFF)
S2. NTSC setup level 7.5 IRE / 0 IRE (ON: 0 IRE, OFF: 7.5 IRE). (See Note 2 below)
S3. Locked Audio (OFF: Locked Audio, ON: Unlocked Audio, factory default)
S4 & S5 setting for different PC Operation System
S6. Factory setting (OFF), please do not change.
*. Note 1: Reboot TLM-70D if you change a DIP Switch
Turn-on TLM-70D before launching any NLE software
*. Note 2: NTSC 0 IRE is most often used in Japan
NTSC 7.5 IRE is used elsewhere
*. PAL Video is always at 0 IRE mode
*. Note 3: To work with a DV source from MAC with Final Cut Pro:
1). Select "Preferences" from Final Cut Pro menu
2). Select "General" page
3). Uncheck "Abort capture on dropped frame"
4). Uncheck "Abort capture on time code break" for Final cut pro
5). Click OK button
ON MAC OS (See Note 3 below)
S5 ON S4
OFF Windows 2000 and Windows 98
ON Windows XP and Windows ME
S5 OFF S4
OFF DV Camera mode