Filter
Top Products
Flash Cache Module
Removing the FCM
1. Follow the procedures in Before You Begin.
2. Turn the computer over and remove the cover on the Mini Card compartment.
3. Ground yourself by touching one of the metal connectors on the back of the computer.
4. Remove the M2 x 3-mm securing screw.
5. Lift the FCM out of its system board connector.
Replacing the FCM
1. Insert the FCM connector at a 45-degree angle into the system board connector labeled "FCM".
2. Press the other end of the FCM down into the slot on the system board until the card clicks into place.
3. Replace the M2 x 3-mm securing screw.
Back to Contents Page
NOTE: If you leave the area, ground yourself again when you return to the computer.
1
FCM Card
2
M2 x 3-mm securing screw
NOTICE: Install the FCM in the WWAN slot. Do not install an FCM in the WLAN card slot. Doing so may cause damage to your computer.