Filter
Top Products
272 Configuring Switch Information
www.dell.com | support.dell.com
Defining GARP Timers Using CLI Commands
This table summarizes the equivalent CLI commands for defining GARP timers as displayed in the
GARP Timers
page.
The following is an example of the CLI commands:
Table 7-73. GARP Timer CLI Commands
CLI Command Description
garp timer {join | leave | leaveall}
timer_value
Adjusts the GARP application join, leave,
and leaveall GARP timer values.
console(config)# interface ethernet 1/e1
console(config-if)# garp timer leave 900
console(config-if)# end
console# show gvrp configuration ethernet 1/e11
GVRP Feature is currently Disabled on the device.
Maximum VLANs: 223
Port(s) GVRP- Registration Dynamic VLAN Timers (milliseconds)
Status Creation Join Leave Leave All
---------
------- -------- ------------ ------------ ------- ------
1/e11 Disabled Normal Enabled 200 900 10000