Dell 760N Computer Drive User Manual


  Open as PDF
of 128
 
3-4 Dell PowerVault 720N, 740N, and 760N Users Guide
8VLQJ6HWXS:L]DUGRQD1HZ)LOHU
:LWKRXWD'+&36HUYHU
'HVFULSWLRQ
This procedure enables you to use the Setup Wizard on a new filer without using a
DHCP server to obtain the new filers IP address. This procedure also enables you to
set up virtual interfaces in your new filer.
After you complete this procedure, the filer is running the protocols for which you pur-
chased licenses, and is configured and ready for use.
3UHUHTXLVLWHV
You need the following requirements completed before you begin the procedure:
Installed filer hardware and the serial console attached to the filer according to
the instructions in your hardware guide
The new filer attached to the network
A client browser on the same network as the filers
e0
network
6WHSV
To give the filer an IP address and to use the Setup Wizard to configure the filer, per-
form the following steps:
1. Turn on the filers power switch to begin the configuration process.
The first time the filer boots up, it runs setup.
If setup does not run automatically, enter
setup
and press Enter.
2. Enter the information as requested.
The following prompt is displayed:
:RXOG\RXOLNHWRFRQWLQX HVHWXSWKURXJKWKHZHE
LQWHUIDFH">Q@
3. Enter
yes
to continue the setup using the Setup Wizard.
The wizard displays the following message:
3RLQWDZHEEURZVHUWR
KWWSILOHUQDPHDSL
RU
KWWSILOHULSDGGUHVVDSL
WRFRPSOHWHVHWXS
 previous next