Filter
Top Products
Back to Contents Page
Display Assembly
Dell™Latitude™D630ServiceManual
Removing the Display Assembly
Removing the Display Bezel
Removing the Display Panel
Removing the Display Panel Brackets
Removing the Display Panel Cable
Removing the Display Hinges
Removing the Display Assembly
1. Follow the instructions in Before You Begin.
2. Remove the hinge cover (see Hinge Cover).
3. Remove the keyboard (see Removing the Keyboard).
4. Review the cable routing diagram:
5. Pull straight up on the pull-tab that is attached to the display cable to disconnect the cable from the system board.
6. Disconnect the antenna cables from their card(s) (see Communications Cards).
7. Carefully remove the antenna cables and the display cable from their routing guides.
8. Close the display.
9. Turn the computer upside down with the back of the computer facing you.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface, such as a connector on the back of the computer.
1
WWAN/FCM card
connector
2
WWAN antenna cables
3
WLAN antenna cables
(black and white)
4
WLAN card
5
pull-tab
6
display cable
7
WLAN antenna cables
(white and gray)
8
WLAN antenna cable (gray;
currently unused)
NOTICE: To avoid damage to your computer, use the illustration above when replacing the display assembly to carefully reroute the cables in the
appropriate cable channels. Route the gray and black antenna cables beneath the white antenna cable, and the black display cable on top of the
white antenna cable.