Filter
Top Products
j. display hinge
k. palmrest
l. ExpressCard cage
m. system fan
n. system board
3. Perform the following steps:
a. Remove the power-connector cable from the routing channels.
b. Lift and remove the power connector from the computer.
Installing the Power Connector
1. Place the power connector on its place in the computer.
2. Route the power-connector cable on its routing channels.
3. Install:
a. system board
b. system fan
c. ExpressCard cage
d. palmrest
e. display hinge
f. WLAN card
g. hard drive
h. optical drive
i. memory
j. keyboard
k. keyboard trim
l. base cover
m. battery
n. SD card
4. Follow the procedures in After Working Inside Your Computer.
Removing the Speakers
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove:
a. SD memory card
b. battery
c. base cover
38