Dell IN2020 Computer Monitor User Manual


  Open as PDF
of 32
 
Back to Contents Page
Setting Up the Monitor
Dell™IN2020/IN2020MmonitorUser'sGuide
Attaching the Base
Connecting the Monitor
Attaching the Soundbar (Optional)
Removing the Monitor Stand
Attaching the Base
After placing the monitor panel on a soft cloth or cushion, complete the following steps to attach the base.
1. Fit the groove on the back of the monitor to the two tabs on the upper part of the stand.
2. Lower the monitor so that the monitor mounting area snaps on to or locks on to the stand.
Connecting the Monitor
To connect your monitor to the computer perform the following steps/instructions:
1. Turnoffyourcomputeranddisconnectthepowercable.
2. Connect the white (digital DVI-D),orblue(analogVGA)displayconnectorcabletothecorrespondingvideoportonthebackofyourcomputer.Donot
use all the cables on the same computer. Use all of the cables only when they are connected to different computers with appropriate video systems.
Connecting the blue VGA cable
Connecting the White DVI Cable* (for IN2020M only)
NOTE: The stand is detached when the monitor is shipped from the factory.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions.
 previous next