Filter
Top Products
Using Your Projector 19
DISPLAY (in PC Mode)
Using the Display menu, you can adjust the display settings of your projectors. The
Display menu provides the following options:
A
SPECT RATIO—Allows you to set the aspect ratio.
• 4:3 - The input source scales to fit the screen.
• Original - The input source scales to fit the screen while keeping the aspect ratio
of the input source.
• Wide - The input source scales to fit the width of the screen.
Use Wide or 4:3 if you are using one of the following:
- Computer resolution greater than SVGA
- Component cable (720p/1080i/1080p)
D
IGITAL ZOOM—Press to digitally magnify an image up to 4 times on the projection
screen and press to reduce the zoomed image.
Z
OOM NAVIGATION—Press to navigate projection screen.
H
ORIZONTAL POSITION—Press to move the image to the right and to move the
image to the left.
V
ERTICAL POSITION—Press to move the image down and to move the image up.
F
REQUENCY—Allows you to change the display data clock frequency to match the
frequency of your computer graphics card. If you see a vertical flickering wave, use
Frequency control to minimize the bars. This is a coarse adjustment.
T
RACKING—Synchronize the phase of the display signal with the graphic card. If you
experience an unstable or flickering image, use Tracking to correct it. This is a fine
adjustment.
DISPLAY (in Video Mode)
Using the Display menu, you can adjust the display settings of your projectors. The