Dell N5010 Laptop User Manual


  Open as PDF
of 51
 
Back to Contents Page
VGA Connector Board
Dell™Inspiron™N5010/M5010ServiceManual
Removing the VGA Connector Board
Replacing the VGA Connector Board
Removing the VGA Connector Board
1. Follow the instructions in Before You Begin.
2. Remove the battery (see Removing the Battery).
3. Remove the base cover (see Removing the Base Cover).
4. Remove memory module(s) (see Removing the Memory Module(s)).
5. Remove the optical drive (see Removing the Optical Drive).
6. Remove the keyboard (see Removing the Keyboard).
7. Remove the palm rest (see Removing the Palm Rest).
8. Remove the display assembly (see Removing the Display Assembly).
9. Remove the middle cover (see Removing the Middle Cover).
10. Disconnect the VGA connector board cable from the connector on the system board and remove it from the routing guide.
11. Remove the VGA connector board from the tab on the computer base.
12. Lift the VGA connector board along with the cable off the computer base.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the
computer.
1
VGA connector board
2
tab
 previous