Filter
Top Products
Using Your Projector 29
3
Using Your Projector
Turning Your Projector On
NOTE: Turn on the projector before you turn on the source (computer, DVD
player, etc.). The Power button light blinks blue until pressed.
1 Connect the power cord and appropriate signal cables to the projector. For
information about connecting the projector, see "Connecting Your Projector" on
page 12.
2 Press the Power button (see "Using the Control Panel" on page 34 to locate the
Power button).
3 Turn on your source (computer, DVD player, etc.)
4 Connect your source to the projector using the appropriate cable. See
"Connecting Your Projector" on page 12 for instructions to connect your source
to the projector.
5 By default, the input source of the projector is set to VGA-A. Change the input
source of the projector if necessary.
6 If you have multiple sources connected to the projector, press the Source
button on the remote control or control panel to select the desired source. See
"Using the Control Panel" on page 34 and "Using the Remote Control" on
page 36 to locate the Source button.
Turning Your Projector Off
CAUTION: Unplug the projector after properly shutting down as explained in
the following procedure.
1 Press the Power button. Follow the instruction displayed on screen to properly
turn off the projector.
NOTE: The "Press Power Button to Turn off Projector" message will
appear on the screen. The message disappears after 5 seconds or you can
press the Menu button to clear it.
2 Press the Power button again. The cooling fans continue to operate for 120
seconds.