Filter
Top Products
26 Quick Reference Guide
www.dell.com | support.dell.com
Running the Dell Diagnostics
It is recommended that you print these procedures before you begin.
1
Open the Dell Diagnostics on your hard drive or from the
Drivers and Utilities
CD.
From your hard drive
:
a
Shut down and restart the computer.
b
When
F2 = Setup
appears in the upper-right corner of the screen, press
<Ctrl><Alt><F10>.
If you wait too long and the Microsoft
®
Windows
®
logo appears, continue to wait until
you see the Windows desktop. Then shut down your computer and try again. After the
system boots to the Dell Diagnostics, go to step 2.
From the Drivers and Utilities CD
:
a
Shut down and restart the computer.
b
When
F2 = Setup
appears in the upper-right corner of the screen, press <F12>.
If you wait too long and the Microsoft Windows logo appears, continue to wait until you
see the Windows desktop. Then shut down your computer and try again.
NOTE: This feature changes the boot sequence for one time only. On the next start-up, the computer
boots according to the devices specified in system setup.
The
Boot Device Menu
appears.
c
Insert the
Drivers and Utilities
CD.
d
Change the
Boot Sequence
to use the IDE CD-ROM device as the first device in the
boot sequence.
The Dell Diagnostics Menu appears.
e
Select
Dell 32-bit Diagnostics
from the numbered list. If multiple versions are
listed, select the version appropriate for your computer.
2
When the
Dell Diagnostics
main menu appears, select the type of test you want to perform.