Delta Electronics 4886 Computer Drive User Manual


  Open as PDF
of 6
 
Integration and Operating Instructions
4886
LA2-1-1025-33
Page Number 5
Attach amplier to heatsink using thin layer of thermal compound. The amplier will produce approximately 20W of heat, so a
medium size heatsink will be adequate - a heatsink with approximate dimensions 2 x the area of the lab amp and approx 1.0”
deep. A smaller heatsink may be used if any airow is used.
Attach RF Input and RF Output using SMA Female connectors and tighten. Install ground wire and Vsup using solder connec-
tions - make sure to attach positive wire to Vsup terminal. If optional disable is ordered, install using disable terminal on input
side of amplier.
To operate, apply Vsup and amplier is ready to operate.
 previous