Filter
Top Products
sensor located on the bottom of the mou-
se will glow red.
Set the ID codes (Figure 2):
1. Press the link button on the receiver.
2. Press the link button on the bottom of the
mouse. When you see the red light flash-
ing that means the mouse and receiver
are communicating successfully.
Mouse power management (Figure 2 & 3):
1. The mouse’s battery power capacity de-
pends on the use of “ON/OFF” switch con-
trol.
2. When power is “ON”, the mouse will go
into “Sleep Mode” after 8 minutes if not
used. You need to press a button or the
scroll wheel to re-activate the mouse.
3. To save the power, turn off the power
while you are not using it or traveling.
4. When the low battery indicator is flashing,
it means the power is not enough. You
should plug the charging cable on both
receiver & mouse for charging. The mou-
se can be used while the batteries are
charging. Make sure the mouse contains
rechargeable batteries!
5. The charging indicator light is located at
the end of the mouse. When you plug the
charging cable in, the red LED will go on.
When the battery is fully charged, the LED
will turn to green. Please pay attention to
the following notes while charging the
mouse:
Note: Please charge at least 10 hours befo-
re the first operation. Make sure PC or Note-
book does not change to the stand by or
sleep mode while charging.
The rechargeable batteries included are de-
signed for a limited number of recharging
cycles. The number of cycles depends on the
device type as well as the recharging process
itself. Incorrect charging of a battery can re-
duce its lifetime and deviate from the lifecycle
of the product. Therefore please charge
the mouse only when the batteries have low
power or are empty.
Federal Communications Commission
Statement
Notice 1
You are cautioned that changes or modifica-
tions not expressly approved by the part
responsible for compliance could void the
user’s authority to operate the equipment.
Notice 2
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reason-
able protection against harmful interference
in a residential installation. This equipment
generates uses and can radiate radio fre-
Fig. 2
Link button
Link button
Charging
cable
Charging
indicator
Charging
ports
ON/OFF switch
Fig. 3