Digi Hubport/4c DC Switch User Manual


 
Hubport Installation Guide (90000664 Rev. B) Page 4
Regulatory & Other Information
© 2006 Digi, Digi International, the Digi logo, the Digi
Connectware logo, Edgeport, and Hubport are either
trademarks or registered trademarks of Digi
International, Inc. in the United States and/or other
countries. All other trademarks are the property of their
respective holders.
Information in this documentation is subject to change
without notice and does not represent a commitment on
the part of Digi International.
Digi International provides this document “as is,”
without warranty of any kind, expressed or implied,
including, but not limited to, the particular purpose.
Digi International may at any time make improvements
and/or changes to this documentation, the product(s)
and/or program(s) described in this documentation.
Digi International assumes no responsibility of any
errors, technical inaccuracies, or typographical errors
that may appear in this documentation, nor liability for
any damages arising out of its use. Changes are made
periodically to the information herein; these changes
may be incorporated in new editions of the publication.
For U.S. Government use:
Any provision of this document and associated
computer programs to the U.S. Government is with
“Restricted Rights.” Use, duplication, or disclosure by
the government is subject to the restrictions set forth in,
subparagraph (c) (1) (ii) of the Rights in Technical Data
and Computer Software clause of DFARS 52.277-7013.
For non-U.S. Government use:
These programs are supplied under a license. They may
be used, disclosed, and/or copied only as supplied under
such license agreement. Any copy must contain the
above copyright notice and restricted rights notice. Use,
copying, and/or disclosure of the programs is strictly
prohibited unless otherwise provided for in the license
agreement.
Federal Communications Commission
(FCC) Regulatory Information (USA only)
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is
encouraged to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
the receiver.
Connect the equipment into an outlet that is on a
circuit different from the receiver.
Consult the dealer or an experienced radio/TV
technician for help.
Warning: The connection of a non-shielded interface
cable to this equipment will invalidate the FCC
Certification for this device.
FCC Regulation - Part 15
Declaration of Conformity (DoC)
This device complies with the requirements of the Code
of Federal Regulations listed below:
FCC Title 47 CFR, Part 15 Class B for a digital device.
Operation is subject to the following two conditions:
This device may not cause harmful interference, and
This device must accept any interference received,
including interference that may cause undesired
operation.
Department of Communication (DOC) Notice
(Canada only)
This Class B digital apparatus meets the requirements
of the Canadian Interference-Causing Equipment
Regulations.
Cet appareil numérique de la Classe B respecte toutes
les exigences du Règlement sur le matériel brouiller du
Canada.
European Community - CE Mark
Declaration of Conformity (DOC)
According to ISO/IEC Guide 22 and EN 45014
Manufacturer’s Name:
Digi International
Manufacturer’s Addr.:
11001 Bren Road East
Minnetonka, MN 55343
declares that the product