Filter
Top Products
TransPort
®
WR44v2 Installation Guide
Page 16
4 Conguration
Once the unit has been installed and powered up, it needs to be congured to communicate with the LAN
and WAN. Conguration is performed either using the Command Line Interface (CLI) or the Web Interface.
The Web Interface (accessed via a web browser e.g. Firefox, IE, Chrome) is the recommended conguration
option for most users.
Note: You will not be able to use the unit for remote communication until you have subscribed to a suitable
mobile/cellular wireless network service.
4.1 Network Settings
The default IP address for the LAN port is 192.168.1.1 with a subnet mask of 255.255.255.0. The unit has a
DHCP server enabled by default which can assign an appropriate IP address to your PC if the PC is congured
to get an IP address automatically. Alternatively you can manually congure your PC to be on the 192.168.1.x
network, for example, with an IP address of 192.168.1.2 and subnet mask of 255.255.255.0. Care should be
taken to ensure that the unit does not conict with other devices that may already be on the network.
4.2 Web Interface
Step 1) Connect to the Web Interface: Open a Web browser (e.g. Firefox, IE, Chrome) on your PC and
navigate to http://192.168.1.1. If successful, you will be prompted to enter a username and password. The
default username is “username”, and the default password is “password”. After you have logged in, it is
strongly recommended that you immediately change the default username and password.
If you are unable to connect to the Web Interface, please refer to the Troubleshooting section on page 21.
Step 2) ConguretheUnit: The easiest way to perform the initial conguration of the unit is by using the
Quick Start Wizard. This wizard allows you to congure the following items where applicable:
• Username and password
• LAN IP settings
• DHCP Server
• Mobile module and connection
• Wi-Fi Access Point