Filter
Top Products
10/100 Fast Ethernet Switch User’s Guide
Overview
7
•
100M LEDs
These indicators are green when port 1 or port 2 is connected to a device
operating at 100Mbps. If either of these LEDs is off, then the port it
corresponds to is either not connected or is connected to a device
operating at 10Mbps.
•
FDX/Col (Collision) LED
This indicator is green when the respective port is operating in full-
duplex mode, and blinks yellow when collisions occur.
Rear Panel
The rear panel of the 10/100 Fast Ethernet Switch includes the power cable
connector and the Duplex Mode Switch.
Figure 3 : Rear Panel
Duplex Mode Switch
The 10/100 Fast Ethernet Switch must be set to the proper duplex mode for
both ports. To change the duplex mode, change the Duplex Mode DIP
switch setting on the back of the 10/100 Fast Ethernet Switch. On the DIP
switch, down is half-duplex, up is full-duplex, and the switch numbers
correspond with the port numbers.