Filter
Top Products
10/100 Fast Ethernet Switch User’s Guide
Overview
11
The following section describes these indicators in detail.
• Power LED
This indicator is green when power is supplied to the device. The Power
LED lights when you connect the power cable to the power receptacle at
the rear of the device, and then plug it in to a power outlet.
• Link/Act LED
This indicator is green when the respective port is properly connected to
a powered-on device and blinks green when packets are being
transmitted or received.
• 100M LEDs
These indicators are green when port 1 or port 2 is connected to a device
operating at 100Mbps. If either of these LEDs is off, then the port it
corresponds to is either not connected or is connected to a device
operating at 10Mbps.
• FDX/Collision (Col) LED
This indicator is green when the respective port is operating in full-
duplex mode, and blinks yellow when collisions occur.
Rear Panel
The rear panel of the 10/100 Fast Ethernet Switch includes the power cable
connector and the Duplex Mode Switch.
Figure 3 Rear Panel