Filter
Top Products
24
CONFIGURATION IN TERMINAL PROGRAM MODE VIA
HYPERTERMINAL OR TELNET
You can use terminal emulation on your PC/workstation for the initial and future
configuration of your DI-701. Windows HyperTerminal or other terminal emulation
applications can be used. The following example was done with HyperTerminal.
If you prefer, a telnet session can be opened directly. Telnet provides the same type of
terminal emulation. For security purposes, the DI-701 uses port 333 for telnet. All of the
following configuration menus are identical in a telnet session, with the exception that any
saved changes that result in the DI-701 rebooting will require you to open a new telnet
session to reestablish a connection with the DI-701.
Getting Started (Hyperterminal)
1. Connect an RS-232 cable from one Serial COM port on your PC to your DI-701’s Serial
Console port.
2. Go to Start àProgramàAccessoriesàCommunicationsàHyperTerminal.
3. When the Hyper Terminal window appears, double-click Hypertrm.
4. Name the new connection appropriately.
5. In the Connect To dialog box, select the COM port that connects to your DI-701.
Figure 9: Connect To:
6. When the dialog box shown in Figure 10 appears, set the Bits per second rate at 38400,
and Flow control at None. Click OK to complete the setting. See Figure 10.
Figure 10: COM 1 Properties
7. Power up the DI-701.