Filter
Top Products
D-Link DGS-1005D Unmanaged Gigabit Ethernet Switch
Mounting the Switch on a Wall
The DGS-1005D can also be mounted on a wall. Two mounting slots are provided on the bottom of the Switch
for this purpose. Please make sure that the front panel is exposed in order to view the LEDs. Please refer to the
illustration below:
A.) Mounting on a cement wall
1. Mount the Nylon screw anchors into a cement wall.
2. Drive the T3 x 15L screws into the Nylon screw anchors.
3. Hook the mounting holes of the switch back on the screws; you have completed the wall-mount.
B.) Mounting on a wood wall
1. Drive the T3 x 15 L screws into the wood wall.
2. Hook the mounting holes of the switch back on the screws; you have
completed the wall-mount.
(1) 3/4 inch minimum
for wood wall
(2) 3 inch minimum
for cement
wall.
Figure 2-1. Mounting the Switch to a Wall
Attaching the Rubber Feet
Use the rubber feet provided. Position and apply the rubber feet to the underside of the DGS-1005D
Switch.
Figure 2-2. Attaching the Rubber Feet
7