Filter
Top Products
DP-301P Print Server Hardware Guide
Unpacking and Installation 11
LPT Indicator Flash Pattern Error Type
steady long flashes Firmware Reload Required
continuously on DRAM Error
One long, two short flashes Timer INT Error
One long, three short flashes Flash Protected
One long, four short flashes Flash ID Error
One long, five short flashes
Flash Erase / Program Error
One long, six short flashes
LAN Controller Error
One long, seven short flashes LAN Memory Error
One long, eight short flashes Parallel Controller Error
One long, nine short flashes LPT Error
steady short flashes EEPROM Error
One long, eleven short flashes LAN I/O Base error
In the event of a Firmware Reload Required error at startup,
proceed according to instructions given in the PS Admin User’s
Guide ("PS Admin Administration" section, under the heading
"Upgrading the Print Server's Internal Firmware").
In the event that any of the other listed error conditions is
encountered on startup, contact your dealer for correction of the
fault.
Operational Test
The PS Admin software includes a Print Test function for
confirmation of print server connections and functions. This
operational test can be performed after you have installed the PS
Admin software and completed the PS Admin procedures for
configuring the DP-301P. See the instructions given in the PS
Admin User’s Guide ("Getting Started Setting up Your Print
Server" section, under the heading "Testing your Print Server").