D-Link DWL-900AP Network Router User Manual


 
When connecting
the DWL-900AP+
Wireless Access Point to
an Ethernet Adapter in a
computer, use a Cross-
Over Ethernet cable.
Connecting The DWL-900AP+ Wireless
Access Point To Your Network
A. First, connect the power adapter to the receptor at the back panel of
the DWL-900AP+ and then plug the other end of the power adapter to
a wall outlet or power strip. The Power LED will turn ON to indicate
proper operation.
B. Using a Straight-Through Ethernet
cable, insert one end of the cable to the
Ethernet port on the back panel of the
DWL-900AP+ and the other end of the
cable to an Ethernet Broadband
Router (i.e., D-Link DI-604) or Switch
(i.e., D-Link DSS-5+). Note: The router
or switch must be connected to the computer to be used to configure
the DWL-900AP+. The Link LED light will illuminate to indicate a
proper Ethernet connection.
C. Computers with 802.11b wireless adapters can connect to the DWL-
900AP+. The DWL-650+ AirPlus Wireless Cardbus Adapter and the
DWL-520+ AirPlus Wireless PCI Adapter will connect, out of the
box
, with the DWL-900AP+, using their default wireless settings.
A. Receptor
for Power
Adapter
Reset Button
Pressing this button
restores the DWL-
900AP+ to its original
factory default
settings.
C. Antenna
Used to wirelessly
connect to
802.11b adapters.
B. Ethernet Port
This is the connection fo
r
the Ethernet Cable to the
Ethernet port on the
Ethernet Broadband
Router or Switch.