Filter
Top Products
25
STACK menu settings
● The following functions are disabled.
- Executing of AUTO KEYSTONE (
Operating Guide → SETUP menu)
- STANDBY MODE (
Operating Guide → SETUP menu)
- AUTO SEARCH (
Operating Guide → OPTION menu)
- Turning on/off AUTO KEYSTONE (
Operating Guide → OPTION menu)
- DIRECT POWER ON (
Operating Guide → OPTION menu)
- AUTO POWER OFF (
Operating Guide → OPTION menu)
- MY SOURCE (
Operating Guide → OPTION menu)
- COMMUNICATION TYPE (
Operating Guide → OPTION menu →
SERVICE → COMMUNICATION)
- CLONING (
Operating Guide → OPTION menu → SERVICE)
● The input source from the following ports cannot be selected.
- USB TYPE A, USB TYPE B, LAN
● When Intellectual Stack is in use, an error message
will be displayed if an error occurs on any of the
projectors.
When an error occurs, a full dialog will be displayed on screen. The
full dialog changes to a small dialog after about 20 seconds without
any key activity. While the small dialog is displayed, pressing the ◄
button displays a full dialog again.
The numbers “1” and “2” above the projector icons represent the Main and Sub
projectors respectively.
Refer to the on-screen messages as shown below and take the necessary
actions to resolve the problem.
Example:
Cover Error: Lamp cover is opened.
Lamp Error: Lamp does not light up.
Fan Error: Problem with cooling fan.
Temp Error: Temperature of the projector is too
high.
Air Flow Error: Temperature of the projector is
too high, check that the exhaust vents are not
blocked.
(continued on next page)
3.7 Important information for Intellectual Stack (continued)
Full dialog
Small dialog