Filter
Top Products
6
Connecting the Optional Power Adapter
An optional 9 Volt, 1.5 A power adapter can also be used to
power the label maker. Connecting the AC adapter to the
label maker disconnects the batteries as a power source.
To connect the power adapter
1. Plug the power adapter into the power connector on the
top, left side of the label maker.
2. Plug the other end of the power adapter into a power
outlet.
Ç Make sure the label maker power is turned off
before you disconnect the power adapter from the
main power source. Otherwise, your most recent
memory settings will be lost.
Inserting the Tape Cassette
Your label maker comes with one tape cassette. Visit
www.dymo.com for information about
purchasing additional tape cassettes.
To insert the tape cassette
1. Lift the tape cassette cover to open the tape
compartment. See Figure 3.
Ç Before using the label maker for the first time,
remove the protective cardboard insert from the tape
exit slot. See Figure 4.
2. Insert the cassette with the label facing up and
positioned between the guideposts.
3. Press firmly until cassette clicks into place. See Figure 5.
4. Close the tape cassette cover.
Figure 3
Figure 4
Remove
cardboard insert
Guideposts
Figure 5
Click!
Click!