Filter
Top Products
Introduction:
Hart Dynamics Electracoustic® Percussion Products are the result of over 15 years of research and development
and represent the most comprehensive electronic percussion instruments available. Easy enough to use for the begin
-
ning drummer with features that allow the most advanced user flexibility never before acheived. To assure proper set up,
take full advantage of your instruments functions, and to enjoy long and trouble free use, please read this Set-up Guide
carefully. For additional assistance you may reference our website or call our technical support line (see below).
How to use this
Guide:
This Set-up Guide is designed to help you configure your instrument to the “power on” stage. Please refer to your Drum
Module Owners Manual for playing and programming. After basic operation is achieved, you will probably want to “fine
tune” settings to your personal style and taste.
Conventions:
TRS stands for Tip / Ring / Sleeve. This is the same as a “stereo” jack,where one input, output or cable can carry two
signals at the same time. You must use a TRS cable for dual trigger instruments and choke functionality
.
Set-up Guide
MONO 1/4” PLUG
STEREO/TRS 1/4” PLUG
INSTALLATION INSTRUCTIONS
STUDIO EPEDAL (SWITCH)
1. Place EPEDAL on floor and position to desired location.
2. Install cable into jack on side of pedal and other end into module input labeled PEDAL, HH PEDAL, HH CONTROL,
ETC...
3. IMPORTANT:
When turning on module, it is very important that pedal is plugged in and in the full open position.
Module must calibrate pedal at power on. If unplugged or depressed, pedal will not function properly and back
-
wards sounds (open-down/closed-up) will occur.
4. Adjust sound module sensitivity and enjoy!
We value your patronage and are very much interested in any comments you might have. You may write or e-mail
us so that we may use your input to continue to provide the best products and services available.
Enjoy!
Peter Hart
Copyright
©
2005 HDI
All information and appearances contained herein are subject to change without notice.
Any reference to trade names and/or trademarks are presumed to belong to their respective commercial entities.
For cable diagrams, specifications and recommended settings for all current drum modules,
please visit our website at
: http://www.hartdynamics.com/support/index.html
If you require additional assistance, you may contact our technical support line at
(850) 654-1455.