Filter
Top Products
6
6
Power
Heating and cool modes
Remote control
Remote control docks magnetically.
Attach the remote control to the
top of the machine with the buttons
facing down.
To operate, point the remote control
toward the front of the base.
Each time the heating mode is selected, it
conducts a short calibration cycle. Airflow will be
automatically controlled during this cycle. Once
the calibration cycle is complete, it will revert to the
selected airflow speed.
Press and hold the power button to run
through the target temperatures.
Cool mode
Press the blue thermostat control button to change the target
temperature to 32°F. The power button light will change from red
to blue. To adjust the airflow speed use the airflow control button.
Heating mode
Press the red thermostat control button until the digital display shows
the desired target temperature. The power button light will change
from blue to red. The red circle will disappear when the target
temperature has been reached. To adjust the airflow speed use the
airflow control button.
Standby
ON/OFF
Airflow speed
control
Sleep timer
Personal
heating mode
Oscillation
ON/OFF
Diffused mode
Thermostat
control
Cool mode
On first use, the machine will default to a
temperature 5°F higher than the detected
room temperature. Thereafter, the machine will
remember the last target temperature set.
Select the desired room temperature. Pressing the
large red button increases the target temperature by
2°F; the smaller red button decreases it by 2°F. The
machine will not operate in heater mode unless the
target temperature is above the room temperature.