RACK-MOUNT INSTALLATION
EATON Powerware
®
9170
+
Rail Kit (9- and 12-SlotCabinets) InstallationGuide S 164201420Rev B
www.powerware.com
4
6. Select the proper holes in the rail that position the cabinet at the
desired location in the rack.
7. Install one equipment rail on each side of the rack using four
10-32
×1/2” flat-head screws per rail.
8. With one person lifting each side of the cabinet, position the cabinet
onto the two equipment rails (see Figure 3).
Carefully slide the cabinet into the equipment rack until the
rack-mount ears of the cabinet are flush with the front vertical rails
of the rack. Verify that the holes in the ears align with the holes in
the rack.
Equipment Rail
Figure 3. Rails Holding UPS Cabinet