Ecom Instruments 50 Clock User Manual


 
ecom instruments GmbH offers a 2-year warranty for function
and materials on this product under the specified operating and
maintenance conditions.
This warranty does not extend to products which have been used
improperly, altered, neglected, damaged by accident or subjected to
abnormal operating conditions or improper handling.
In the event of a warranty claim, the faulty device should be sent in.
We reserve the right to readjust or repair the unit.
The above warranty terms represent the sole rights of the
purchaser to compensation and apply exclusively and in place of all
other contractual or statutory warranty obligations.
ecom instruments GmbH does not accept liability for specific, direct,
indirect, incidental or consequential damages or losses including the
loss of data, regardless of whether they are caused by breach of war-
ranty, lawful or unlawful actions, actions in good faith or other actions.
If in certain countries the restriction of statutory warranty and the
exclusion or restriction of incidental or subsequential damages is
unlawful, then it may be possible that the above restrictions and exclu-
sions do not apply for all purchasers. If any clause in these warranty
terms should be found to be invalid or unenforceable by a competent
court, then such a judgement shall not affect the
validity or enforceability of any other clause contained in these warran-
ty terms.
11. Declaration of EC Conformity
1918
7.3 Wall Mounting
An integral metal bracket located on the rear of the clock enables the
Ex-Time 40 / 50 to be suitably mounted on an appropriate wall. The
fixing of the unit must be secure at all times and precautionary measu-
res must be taken to prevent the Ex-Time 40 / 50 from
falling into an area classified as zone 0.
7.4 Time Setting
The white adjusting wheel on the quartz mechanism is used to make
any necessary time adjustments.
8. Repairs
Repairs are subject to the terms and conditions of ELEX V. It is recom-
mended that all repairs are carried out by the manufacturer, so as to
check and test the safety and reliability of the unit after any repairs are
performed.
9. Cleaning, Maintenance and Storage
The entire back face of the unit must only be cleaned with a damp
cloth Do not use solvents or abrasive cleaning agents to clean the unit.
We recommended having the function and the accuracy of the device
checked by the manufacturer every two years.
The batteries should be taken out of the unit if it is to be out of use for
a length of time. The storage temperature should be within the permit-
ted range of 0°C to +50°C.
10. Guarantee and Liability
BAL Ex-Time 40/50 29.04.2003 14:46 Uhr Seite 18