Edimax Technology ER-5390S Switch User Manual


 
6
6
Trouble-shooting
1. Power LED is not lit
l Check if the external power adapter is plugged into the power outlet. Make sure
the DC power jack is firmly plugged into the power socket of the hub.
2. LNK/Rx LED is not lit after connecting to an active workstation
l Check the power switch of the network devices attached to the hub; make sure
they are turned ON.
l Check the network cable; make sure it is properly connected to the hub and the
network device.
l Check the network cable; make sure the cable complies with EIA/TIA 568
specification. Use straight-through minimum Category 3 grade cables.
l Do not use uplink port to connect to a workstation.
l The BNC ports Rx LED normally is not lit unless theres data transmission on the
coaxial cable.
3. Uplink (8th) ports LNK/Rx LED is not lit after uplink to another hub
l Check the network cable; make sure it is properly connected to both hubs. One
end of the cable should be connected to uplink port while the other end of the
cable should be connected to a regular port. Do not connect the cable to another
uplink port.
l Check the network cable; make sure the cable complies with EIA/TIA 568
specification.
l Check the length of the network cable does not exceed 100 meters (300 feet).
l Make sure both hubs are powered ON.
4. Partition LED is lit
l Its normal that the BNC ports partition LED is lit when theres no coaxial cable
is attached. Once the cable is attached, the BNC partition LED shall be off within
seconds.
l Check the connected devices. The hub will automatically partition a defective
Ethernet device which causing excessive errors.
8