Filter
Top Products
2. Unpacking and Inspection
Caution:
Under ordinary circumstances, this adapter card will not be affected by static charge as may
be received through your body during handling of the unit. In special circumstances where
you may carry an extraordinarily high static charge, it is highly recommended for you to
reduce the charge by touching a ground before handling the adapter card.
Open the shipping gift box and carefully remove all items. Please check the following items:
y One EN-9235TX-32 Gigabit Ethernet PCI Adapter
y One driver/manual CD
3. Installing the Adapter
1. Turn off the computer.
2. Remove the computer’s cover in accordance to its manual.
3. Insert the contact edge of the adapter card into the connector of any available PCI Bus
master expansion slot. Press the card firmly into the connector to PCI slot. Please make
sure that the card’s contacts are fully seated in the PCI slot.
4. Install the bracket screw that secures the card to the computer chassis.
5. Replace the computer’s cover.
6. Connect the CAT3 or CAT5 UTP cable to the RJ-45 network connector.
7. Remove driver CD from the PC’s CD-ROM drive.
8. Turn on the computer.
9. If the BIOS section of your computer’s boot program is Plug-and-Play compliant, then at
power up the BIOS will automatically configure any newly installed adapter.
Note:
Due to some Plug-n-Play BIOS programs' problem, a newly installed adapter, may
occasionally be assigned an interrupt number that is already used by another device adapter.
In such case, the conflict of interrupt number will cause faults in the behavior of both devices.
Therefore it is necessary to run the CMOS Setup utility, and manually assign a non-conflict
Interrupt Number.
4. Driver CD
The diver CD contains all the popular operating system drivers such as:
y Windows 98SE/ME/NT4.0/2000/XP/Vista
y MAC OS 10.4x and up
y Linux
y Novell Netware 4.X/5.X/6.X
Note:
If any of the listed items are missing, please contact your distributor or reseller.