Filter
Top Products
Focus Spot 250™
©Elation Professional® - – Focus Spot 250™
SPOT – This function allows you to optimize the lamp without the use of an external
DMX controller. In this mode, the device will not react to any control signal.
1. Access the main menu.
2. Tap the UP button until SPEC is displayed, press MODE/ENTER.
3. Tap the UP button until DFSE is displayed, press MODE/ENTER.
4. The display will show ON/OFF .
5. Press the UP button to display ON to activate this function, or OFF to
deactivate this function.
6. Press MODE/ENTER to confirm.
7. Press EXIT to return to the main menu.
DFSE - With this function you can restore the factory settings of the device. All
settings will be set back to the default values. Any edited scenes will be lost. When
restoring the factory settings the unit must be set to the address that the unit was in
when you started editing.
When you exit this function, the unit will begin to reload
data.
1. Access the main menu.
2. Tap the UP button until SPEC is displayed, press MODE/ENTER.
3. Tap the UP button until DFSE is displayed, press MODE/ENTER.
4. The display will show ON/OFF .
5. Press the UP button to display ON to activate this function, or OFF to
deactivate this function.
6. Press MODE/ENTER to confirm.
7. Press EXIT to return to the main menu.
VER - Use this function to display the Software version of the unit.
1. Access the main menu.
2. Tap the UP button until SPEC is displayed, press MODE/ENTER.
3. Tap the UP button until VER is displayed, press MODE/ENTER.
4. The display will show V-1.0”, the display may also show, V-2.0”, V-9.9 etc.