Filter
Top Products
Focus Spot 250™
©Elation Professional® - – Focus Spot 250™
8. Repeat steps 5-8, until you finish setting all the DMX values for all the channels of
this scene, each scene can have 15 channels maximum.
9. Once all the channels are completed, the display will .ash TIME , this stands for
the time needed to run this scene.
10. Press MODE/ENTER to edit the time needed, the display shows T-XX , XX
stands for the time needed to run this scene. For example, T-02 means scene 1
needs 6 seconds to run, T-15 means this scene needs 45 seconds to run.
Note: XX is always three seconds not one second.
11. Adjust the time needed by pressing the UP button.
12. Press MODE/ENTER to save the settings for the scene you are editing, the
display will change to the next scene automatically.
13. Repeat steps 3-12 to edit other scenes, you can edit and save 48 scenes
maximum.
14. Press EXIT to exit, now you have edited and saved scenes using the control
board. The number of steps can be defined under EDIT and the scenes can be
called up under Run . To run the scenes see page 26.
Editing procedure 2: Using an external controller.
1. Access the main menu.
2. Tap the UP button until EDIT is displayed. Press MODE/ENTER.
3. The display will show SC01 , this stands for the first scene number to be edited.
For example: If SC01 is displayed, you will be editing scene 1.
4. Change the scene number by pressing the UP button.
5. Press MODE/ENTER, the display will show C-01 , the 1 stands for the
channel number 1.
6. Press the UP button until CEDT is displayed, press MODE/ENTER.
7. The display will show OFF , press the UP button so that ON is displayed,
press MODE/ENTER.
8. The display shows SC02 . You have successfully downloaded the .rst scene.