Elmo CRP-26 Projector User Manual


  Open as PDF
of 77
 
18
The preparation display will disappear
after 30 seconds.
(See page 52 for Lamp control status.)
Turning On the Projector
Connect the projector’s AC power cord into an AC
outlet. The POWER indicator lights red. Open the lens
cap (see pages 8, 60).
Press the ON/STAND-BY button on the top control or
on the remote control. The POWER indicator lights
green and the cooling fans start to operate. The
preparation display appears on the screen and the
countdown starts.
2
3
1
Complete peripheral connections (with a computer,
VCR, etc.) before turning on the projector.
Selected Input Source and Lamp Control
Note:
The Filter warning and Lamp replacement
icons may appear on the screen
depending on the usage state of the
projector.
Basic Operation
16
Lamp control status
Video
4
After the countdown, the input source that was selected
the last time and the lamp control status icon (see page
52) appear on the screen.
Note:
•WhentheLogoselectfunctionissettoOff, the logo will
not be shown on the screen (p.46).
•WhenCountdown off or Off is selected in the Display
function, the preparation display will not be shown on
the screen (p.45).
•WhentheInputSearchfunctionissettoOn2, the input
signal will be searched automatically (p.44).
• WhenOff is selected in the Display function, the Video/
PC selection window and the input signal guidance
window are not shown on the screen. (p.45)
5
Ifthereisnosignalinputwhenstartontheprojector,
or the current signal is missed while operating the
projector, the Video/PC selection window will be
displayed on the screen, please move the pointer to
input source desired by pressing the Point ▲▼ buttons
and press the SELECT button. And then follow the
input signal guidance window to correct the signal and
connection.
IftheprojectorislockedwithaPINcode,PINcodeinput
dialogboxwillappear.EnterthePINcodeasinstructed
on the next page.
Video / PC selection window
Input signal guidance window
Video / PC selection window
Input signal guidance window
Project Video
Project Computer
Cancel
Project Video
Project Computer
Cancel
Project Computer
No signal
CurrentInputsetting:Video
Issignalprocessedcorrectly?
Iscableconnectedproperly?
No signal
CurrentInputsetting:RGB
Issignalprocessedcorrectly?
Iscableconnectedproperly?
Remote Control of the document camera
POWER button
Note:
- The projector can be turned ON or OFF by pressing
the POWER button on the remote control of the
specified document camera ("L-1ex/TT-02RX" or "L-1n/
TT-02s").
- The projector can be turned off with this remote by
pressingonce;however,the"PowerOff?"indicatoron
the screen will not be displayed.
-WhilethePOWERindicatorisblinking,thelampis
being cooled down and the projector cannot be turned
backon.
 previous next