Filter
Top Products
Fig:4
Remove fan housing by using thumbs to
unfasten clips and place fan in housing
(Fig. 4). Snap fan housing back into the
chassis. Connect fan and speaker wiring
to M/B as instructed in M/B user
manual (After M/B is installed!).
Install 3.5" HDD and FDD (floppy)
A. Squeeze tabs on side and remove 3.5"
drive cassette (Fig. 5). Slide HDD into
cassette and fasten with coarse thread
flat head screws. Make sure EMI clip is
In place.
B. Slide floppy into the same cassette and
fasten with fine thread flat head screws.
Then slide cassette back in to drive bay
And snap in to place.
Install CD-ROM, (DVD or 5.25" FDD)
A. Fasten slide guides to the sides of
CD-ROM (DVD or 5.25" FDD) using
fine thread flat head screws (Fig. 6).
B. Slide CD-ROM in to 5.25" bay and
snap in to place (Fig. 7)..
Fig:5
Fig:6
Fig:7
Series EN-7100
Fig:3
Fig:1
Fig:2
***Important-First please check your model number before proceeding. The user
manual is set up to correspond to the model number and installation will vary
depending on the model.
Required tools: Phillips head screwdriver, pliers
***(Photos shown may vary according to model number)
Place case on edge of table (Fig.1). With one
hand holding top of chassis, pull quickly from
the bottom of the bezel to remove it (Fig. 2).
**Note-It might require some force to remove
due to the snug fit to the chassis.
Remove screws. Place hands on sides of
top cover and thumbs firmly on chassis.
Slide top cover towards you 1" (Fig. 3).
Spread sides and lift straight up to remove.