Support User Manuals

Enterasys Networks 4H4203-72 Network Hardware User Manual

Open as PDF

of 90

Setting the Mode Switches

B-2 Mode Switch Bank Settings and Optional Installations

Setting the Mode Switches

Figure B‐1andFigure B‐2showthelocationofthemodeswitchesandtheswitchsettings

fornormaloperation.Theseswitchesaresetatthefactorytotheoffpositionandrarely

needtobechanged.

Switchdefinitionsandpositionsareasfollows:

•Switches1through6–ForEnterasysNetworksuse

only.

•Switch7–ClearPersistentData.ChangingthepositionofthisswitchclearsPersistent

Dataonthenextpower‐upofthemodule.Alluser‐enteredparameters,suchastheIP

address,modulenames,etc.,areresettothefactorydefaultsettings.Oncethemodule

resets,youcan eitheruse

thefactorydefaultsettingsorreenteryourownparameters.

•Switch8–ClearAdminPassword.Changingthepositionofthisswitchclearsthe

adminpassword,andrestoresthefactorydefaultpasswordonthenextpower‐upof

themodule.Oncethemoduleresets,youcaneitherusethefactorydefaultsettings

or

reenteryourownpassword.

Caution: Read the appropriate sections to be fully aware of the consequences when

changing switch settings.

Only qualified personnel should change switch settings.

Precaución: Si desea modificar la configuración del interruptor, lea las secciones

correspondientes para saber cuál será el resultado de hacerlo.

Estas modificaciones a la configuración sólo debe realizarlas personal calificado.

Note: Do not change the position of Switch 8 unless it is necessary to reset the admin

password to its factory default setting.

previous next