Filter
Top Products
16 TM-T88V User’s Manual
English
DIP Switch Tables
When using Serial Interface
*1: When DIP switches 1-7 and 1-8 are on, the transmission
speed can be selected from one of seven speeds:
2400, 4800, 9600, 19200, 38400, 57600, and 115200 bps
by control commands.
When using Parallel Interface
DIP Switch Bank 1
SW Function ON OFF
1-1 Data receive error Ignored Prints “?”
1-2 Receive buffer
capacity
45 bytes 4KB
1-3 Handshaking XON/XOFF DTR/DSR
1-4 Data word length 7 bits 8 bits
1-5 Parity check Enabled Disabled
1-6 Parity selection Even Odd
1-7
1-8
Transmission speed (See table A.)
DIP Switch Bank 2
SW Function ON OFF
2-1 Handshaking
(BUSY condition)
Receive buffer
full
Offline or
Receive buffer
full
2-2 Do not change
settings
Fixed to OFF
2-3
2-4
Print density See Table B
2-5 Release condition of
receive buffer BUSY
(If receive buffer
capacity set to 4KB.)
Releases BUSY
when remaining
receive buffer
capacity
reaches
138 bytes.
Releases BUSY
when remaining
receive buffer
capacity
reaches
256 bytes.
2-6 Do not change
setting.
Fixed to OFF
2-7 I/F pin 6 reset Enabled Disabled
2-8 I/F pin 25 reset Enabled Disabled
Table A
Transmission speed (bps) bits per second SW1-7 SW1-8
38400
*1
ON ON
4800 OFF ON
9600 ON OFF
19200 OFF OFF
DIP Switch Bank 1
SW Function ON OFF
1-1 Auto line feed Always
enabled
Always disabled
1-2 Receive buffer
capacity
45 bytes 4KB
1-3 Select paper sensors
to output paper-end
signals (default value
of a command) from
parallel I/F.
Disabled Roll paper end
sensor enabled,
Roll paper near-
end sensor
enabled
1-4 Error signal output
from parallel I/F
Disabled Enabled
1-5~
1-8
Undefined
DIP Switch Bank 2
SW Function ON OFF
2-1 Handshaking
(BUSY condition)
Receive buffer
full
Offline or
Receive buffer
full
2-2 Do not change
settings
Fixed to OFF
2-3
2-4
Print density See Table B
2-5 Release condition of
receive buffer BUSY
(If receive buffer
capacity set to 4KB.)
Releases BUSY
when remaining
receive buffer
capacity
reaches
138 bytes.
Releases BUSY
when remaining
receive buffer
capacity
reaches
256 bytes.
2-6
2-7
Do not change
setting.
Fixed to OFF
2-8 I/F pin 31 reset
signal (Do not
change setting)
Fixed to ON
Table B
Print density/low power SW2-3 SW2-4
Print density “Normal” OFF OFF
Print density “Medium” ON OFF
Print density “Dark” OFF ON
Do not set ON ON