Epson 3490 Scanner User Manual


  Open as PDF
of 6
 
Epson Perfection 3490 Photo
6 - Epson Perfection 3490 Photo 6/05
If an error occurs, the scanner stops operating and the scanner
light flashes red. This indicates one of the following problems:
❏ The scanner is not connected to your computer properly or
your software is not fully installed. See the Start Here sheet
that came with your scanner for instructions on installing
the scanner software and connecting the scanner to your
computer.
❏ The scanner transportation lock is locked. Slide the lock to
the unlock position.
After trying these solutions, turn off the scanner by unplugging
its power cord, then plug it in to turn it back on. If the scanner
light is still flashing:
❏ The scanner may be malfunctioning.
❏ The scanner lamp may need to be replaced.
❏ The connected optional equipment may be malfunctioning.
Transporting the Scanner
Before transporting the scanner for a long distance or storing it
for an extended period of time, you need to lock the scanner’s
carriage to prevent damage.
1. Plug in the scanner, connect it to your computer, and wait
until the carriage moves to the home position (position
nearest the buttons). While the
] Start light is green,
unplug the scanner.
2. If the cover cable is attached,
disconnect it.
3. To lock the transportation lock, lift
the scanner and slide the lock to the
locked position. This secures the
carriage.
Caution: Do not turn the scanner over; this may damage it.
4. Attach the protective materials and repack the scanner in its
original box.
Related Documentation
CPD-19431 Epson Perfection 3490/3590 Photo
Start Here sheet
CPD-19432 Epson Perfection 3490/3590 Photo
Scanner Software CD-ROM
CPD-19433 Epson Perfection 3490/3590 Photo
Notices booklet
— Epson Perfection 3490/3590 Photo
User’s Guide (HTML)
 previous