Filter
Top Products
Quick Setup
Choose a location
The projector supports 4 viewing setups. Choose the best one for
your environment. If you install the projector in a rear or overhead
position, you’ll need to choose the correct projection option,
identified below, from the Extended menu. See the User’s Guide
on your CD-ROM for instructions.
Table
Convenient for temporary front projection.
Choose Front from the menu.
Ceiling
Professional installation recommended.
Choose Front/Ceiling from the menu.
Rear
For installation behind a translucent screen.
Choose Rear from the menu.
Rear/Ceiling
Professional installation recommended.
Choose Rear/Ceiling from the menu.
The distance between the projector and the screen determines
the size of the image. The diagram below shows approximately
how big your image will be (diagonally), based on where you set up
the projector. (For more help determining the size of your image,
try the Image Size Calculator on the Multimedia Projectors page on
Epson’s website.)
2 Connect your video source
Connect the projector to a computer or video source using any of the available
connections shown below.
•
Check the connectors on your video equipment. If more than one
connection is available, choose the one that provides the best quality.
The projector connectors from highest to lowest quality are
Computer (Component Video), S-Video, and Video.
•
A computer cable is included. You can purchase optional video and
audio cables through Epson or an electronics store.
•
You can connect up to 4 video devices and use the remote control to
switch between them.
You can also connect an external monitor to watch the display
on your computer monitor while watching the projection screen
(when the computer cable is connected to the Computer1 port). To
enhance the sound in your presentation, you can connect external
speakers. See the User’s Guide on your CD-ROM for instructions.
3 Set up the remote control
1 Remove the battery cover.
2 Insert the batteries.
3 Replace the battery cover.
The remote control is ready for use.
Turn over
PowerLite
®
822+/83+
1 Unpack the projector
You should have the following items:
Projector Power cord
Computer cable
User’s Guide
CD-ROM
Password Protected
sticker
Remote control
and batteries
RCA video cable
(composite video)
(optional)
S-Video
cable
(optional)
Component
video to
VGA cable
(optional)
Computer
cable
(included)
L-Audio-R
ports
Audio2 and Audio1 ports