EPSON ActionPC 7000, ActionTower 7000, Endeavor 486i
Power Supply
Type
200 Watt, UL/TUV/CSA listed, fan-cooled
Input ranges
100-120 VAC or 200-240 VAC;
switch-selectable
Maximum
+5 VDC at 20 Amps, -5 VDC at 0.5 Amp
output
+12 VDC at 8 Amps, -12 VDC at 0.5 Amp
Frequency 50 to 60 Hz
Cables
Two to main system board, five to mass
storage devices; for more than five
devices, Y cables can be installed on the
existing cables
Option slot power limits
CPU type jumper settings
Output voltage (VDC)
1 +5 Volts
1 -5 Volts
Environmental Requirements
Condition
Temperature
1 Operating range
141°t0900F
1 Storage range
I-4’
to 140° F
+
Humidity
(non-condensing)
Altitude
-330 to
9,900 ft
-330 to
39,600 ft
Jumper Settings
Miscellaneous jumper settings
Function
Enables on-board l/O controller
Disables on-board l/O controller
Selects 5V flash ROM
Selects 12V flash ROM
EPROM
Enables PCI IDE controller
Disables PCI IDE controller
Clears CMOS memory (resets SETUP values to
factory defaults)
Normal CMOS values
Enables on-board VGA controller
Disables on-board VGA controller
I
4
I
,,,,
I
I
* Default setting
Parallel port ECP mode DRQ jumper settings
Function JP8 JP18
DRQ1 (DACK1)*
1-2
2-3
DRQ4 (DACK3) 2-3
1-2
* Default setting
5/19/95 ActionPC 7000, ActionTower 7000, Endeavor 486i - 3