Filter
Top Products
9
EMP Monitor Operation Guide
If a Projector Cannot be Monitored or Controlled Using EMP Monitor
Cause Remedy
Is the projector connected to
the network correctly?
Connect the network cable correctly.
s
"Network Cable Connections" in the
User's Guide
Has the projector been set
up correctly for connection
to the network?
Check the projector's network settings.
If using EMP-835
s
"Connecting in
Access Point Mode or Wired LAN Mode"
in the EasyMP Network Setup Guide
If using EMP-830
s
"Projector Network
Connecting Settings (EMP-830)" in the
User's Guide
Has EMP Monitor been
installed to the computer
correctly?
Uninstall EMP Monitor and then re-install
it.
Have all projectors that are
to be monitored and
controlled been registered in
the projector list?
Register the projector in the projector list.
s
p.3
Is the projector's "Standby
Mode" configuration menu
set to "Network ON"?
In order to use EMP Monitor to monitor
and control the projector when it is in
standby mode, the projector's
"Extended" - "Standby Mode"
configuration menu must be set to
"Network ON".
s
"List of Configuration Menu
Commands" in the User's Guide