Filter
Top Products
Tractor
When you use the tractor as a pull or push tractor, leave this
option set to Single. If you install an optional tractor and use both
tractors as a push-pull tractor, set it to Double.
Interface
When this feature is set to Auto, the printer determines which
interface is receiving data and switches to that interface until the
end of the print job (when no data is received from the selected
interface for the amount of time specified). You can specify either
10 seconds or 30 seconds.
Set this option to Parallel only if you want the printer to ignore
data from the serial interface or to Serial only if you want the
printer to ignore data from the parallel interface.
Bit rate, parity bit, data length, and ETX/ACK
These options are available only when the interface is set to Serial.
See your computer manual for the appropriate settings.
Installing and Using Options
Cut-sheet feeder
The optional single-bin cut sheet feeder (C80637✽) handles up to
50 sheets of standard bond paper ( 82 g/m
2
or 22 lb) without
reloading. Follow these steps to install the cut sheet feeder:
1. Make sure the printer is turned off. Remove the paper guide.
2. If the tractor is installed in the pull-tractor position, remove it
and re-install it in the push-tractor position.
3. Make sure the paper-release lever is in the single-sheet position.
L
Blueberry REV.D
A5 size Chapter 2
95/01/20
2-24 Using the Printer