Filter
Top Products
Using the Projector
33
Follow these instructions to use your remote control as a wireless
mouse:
■
Aim the remote at the screen or at the receiver on the front of the
projector. To move the mouse pointer on the screen, press the
edges of the
Enter
button with your thumb, as you would to
move a trackball.
■
To click, press down on the center of the
Enter
button. To
double-click, press down twice on the
Enter
button.
■
To click and drag, press down on the
Enter
button and then tilt it
in the direction you want to drag.
■
To right-click, press the
Esc
button.
■
To change slides in a PowerPoint
®
presentation (in Slide Show
mode), press down on the
Enter
button.
Controlling Audio and Video
While giving your presentation, you may want to switch between
picture sources, temporarily turn off or freeze the picture, or adjust the
volume.
Make sure you’ve first set up your projector and connected your audio
or video source as described in Chapter 1.
Switching Between Picture Sources
You can connect the projector simultaneously to one computer source
and one video source. Then you can use the buttons on the projector
or remote control to switch between them.
■
Press the
Source
button on the projector to switch between
computer, S-video, and composite video sources.
■
Press the
Computer
,
Video
, or
S-Video
button on the remote
control to select the source you want to use.
After you select a source, the screen goes dark for a moment before the
image appears.
Press center
to left-click
Press
here to
right-click
Press edges
to move the
pointer
note
If you swapped the mouse
button functions on your
computer mouse, the
Enter
and
Esc
buttons on the
remote control also swap
functions.
Select
Computer,
Video, or
S-Video